Bently Nevada 330103-00-08-05-02-05 3300 XL 8mm Proximity Probe Sensor

Product Overview

The Bently Nevada 330103-00-08-05-02-05 belongs to the advanced 3300 XL 8 mm Proximity Probe series. Engineers deploy this metric sensor for precise vibration and position measurements in high-speed rotating machinery. The unit features an M10x1 thread profile, an 80 mm case length, and a total cable length of 0.5 meters. Equipped with a miniature coaxial ClickLoc connector, it ensures secure signal transmission in demanding industrial environments. Polyphenylene sulfide probe tips and stainless steel cases protect internal components from harsh conditions.

Technical Specifications

• Brand: Bently Nevada
• Model / Part Number: 330103-00-08-05-02-05
• Series: 3300 XL Series
• Module Type: 8 mm Proximity Probe Sensor

Installation Guide

• Mount the probe into an M10x1 threaded hole using a maximum thread engagement of 15 mm.
• Set the initial mechanical gap to -9 Vdc, corresponding to roughly 1.27 mm or 50 mils from the target shaft.
• Route the field wiring away from high-voltage power lines to prevent electromagnetic interference.
• Terminate shield wires correctly at the monitor ground terminal to maintain noise rejection.

Debugging & Maintenance Convenience

• Verify probe DC resistance across center and outer conductors to check for internal shorts or breaks.
• Inspect the Viton O-ring seal regularly during outages to prevent fluid ingress at the pressure boundary.
• Measure output voltage at the Proximitor common terminal to confirm correct static gap setup.

Compatibility & Selection Guide

• Compatible exclusively with 3300 XL 8 mm Proximitor Sensors matching system length configurations.
• Pair this sensor with a 3-conductor shielded triad field cable up to 305 meters in length.

Certification Information

• CSA, ATEX, and IECEx hazardous area approvals for zone and division installations.
• Intrinsically safe zener barrier and galvanic isolator compliance for explosive atmospheres.

Package Contents & Fulfillment Terms

• Package Contents: One 330103-00-08-05-02-05 metric proximity probe with integrated ClickLoc connector.
• Warranty: 12-month comprehensive warranty covering factory defects.
• Shipping Logistics: Fast dispatch within 24 to 48 hours via FedEx, UPS, and DHL.

Typical Application Scenarios & Diagnostic Capabilities

• Measures radial vibration and axial position on steam turbines, compressors, and large pumps.
• Detects shaft orbit patterns, eccentricity, and rotor unbalance in real time.
• Identifies bearing wear and impending mechanical rub conditions before catastrophic failure occurs.

Frequently Asked Questions

What happens if the probe is exposed to temperatures below -34°C?
Temperatures below -34°C can harden the Viton O-ring seal, potentially causing premature failure of the pressure boundary seal.

How do I verify if the probe tip is damaged while installed?
Measure the nominal probe DC resistance. A reading outside the expected range indicates an open circuit or internal short within the probe assembly.

Can I use a standard two-wire cable for field wiring?
Engineers recommend a three-conductor shielded triad cable to maintain system accuracy and prevent common-mode noise interference over long distances.

What is Global PLC Spare HUB's Insight on mounting depth adjustments?
Global PLC Spare HUB recommends locking the jam nut securely after setting the gap to prevent vibration-induced shifting during continuous industrial operation.

Tags