IC694ALG220 PACSystems RX3i GE Fanuc Analog Input Module Unit

Product Overview

The IC694ALG220 is a high-speed 4-channel analog input module engineered by GE Fanuc for the scalable RX3i PacSystems architecture. Designed to process precision industrial sensor signals, this module provides rapid conversion rates and flexible voltage or current loop input scaling across every compatible GE Fanuc CPU framework.

Configuration Breakdown & Technical Specifications

• Brand: GE Fanuc
• Manufacturer Part Number: IC694ALG220
• Product Series: RX3i PacSystems
• Module Type: Analog Input Module
• Number of Channels: 4 independent input points
• Input Voltage Span: -10 to +10 Volts DC
• Input Current Span: 4 to 20 milliamps (via terminal jumper configuration)
• Channel Conversion Speed: 1 millisecond per channel
• Total Channel Update Rate: 4 milliseconds
• Backplane Power Load: 27 mA and 0.135 Watts at 5V DC
• Hot Swapping: Not Supported (Requires system power down before installation)

Packaging List & Commercial Terms

• One IC694ALG220 PACSystems RX3i analog input module unit
• Removable terminal block connector interface
• Factory compliance documentation and installation sheet
• Warranty: Full 12-month comprehensive replacement coverage
• Fulfillment: Express priority global delivery via FedEx, UPS, and DHL within 24-48 hours

Target Machinery & Application Scenarios

• Continuous process control flow, pressure, and level transmitter loops.
• Precision temperature monitoring systems utilizing standard DC signal conditioners.
• Industrial boiler and turbine thermal management instrumentation networks.
• Skid-mounted wastewater treatment chemical dosing control skids.

Diagnostic Capability

• High-speed 1ms conversion per channel allows real-time capture of fast transient process variable changes.
• RX3i CPU diagnostics continuously monitor backplane communication integrity and flag open-wire loop faults.
• Precise signal scaling flags out-of-range sensor inputs before process values impact automated control routines.

Global PLC Spare HUB's Insight

When engineering loop connections for the IC694ALG220, instrument technicians must pay close attention to backplane power distribution. When mounted in a universal backplane, an external 24V DC supply routed through the left-side TB1 connector is mandatory, whereas remote expansion racks rely on isolated internal power supplies. Always de-energize the rack before card insertion to prevent destructive bus arcing.

Frequently Asked Questions

Question: What happens if an attempt is made to hot swap this module while powered?

Answer: Hot swapping is strictly prohibited; inserting or removing the card under power can cause permanent device failure or severe electrical injury.

Question: How are 4-20mA current loops configured on this voltage-capable module?

Answer: Current loops are established by installing appropriate physical jumper wires across the module's input terminal blocks according to the installation manual.

Question: Why is an external 24V DC power source required on universal backplanes?

Answer: Universal backplanes require auxiliary loop power fed through the TB1 connector to drive analog circuitry properly, unlike isolated remote racks.

Question: What is the exact update rate across all four active channels?

Answer: While individual conversion speed is 1 millisecond per channel, the total scan update rate for all four active points completes in 4 milliseconds.

Question: How can I select the correct replacement card for legacy GE systems?

Answer: Verify that your control rack runs an RX3i CPU family and check that your field sensor outputs match the -10V to +10V or 4-20mA input matrix.

Buying Guide

• Confirm that your existing RX3i backplane configuration can accommodate the module's 5V DC power bus load of 27 mA.
• Ensure field transmitters are correctly wired for either voltage or jumpered current modes prior to system startup.
• Select expedited air delivery via DHL, FedEx, or UPS to prevent costly project staging delays.

Tags